New Easy Setup Travel Trailer Cover Fits RV Camper with Assist Steel Pole (30′-33′)

3 layer polypropylene top fabric keeps out rain and snow while single layer polypropylene side fabric venting inside vapor out
Multiple zippered panels for easy access to the front, back & sides
Air vents reduce wind stress and vent inside moisture out

This RV cover is designed for a new installing method. It might save quite a lot of it slow.

1.Adjustable front & rear tension panels provide a custom-like fit

2.More than one zippered panels for simple get right of entry to to the front, back & sides

3.Reflective panels for protected parking at night

4.Air vents cut back wind lofting and inside of moisture

5.Reinforced corner patches withstand tears and snags

6.Elasticized bottom corners for fast and easy fitting

7.Unique Rope tie down aid

8.Full cut to permit room for ladders,air conditioners and the like.

9.Easy installation,easy removal

10.Free Storage bag and ladder cap included

11. With a pair of lend a hand steel pole to boost and pull your cover

 

New Installing Method

1. Unpack the quilt, spread it on ground, unzip the zippers of BACK panel of RV cover, roll up BACK panel completely and protected it on best panel with sew-in velcro tapes.(Tip: Spread all of the cover on clean ground, find out the front panel or back panel first, DO NOT OPERATE ON DIRT GROUND!)

2. There are 2 pockets on each and every side panel best near the tip of the quilt. 2 person point the steel poles into each and every pocket and lift it up at the same time

3. Either one of operators stand by the tip of RV, raise the quilt up over the roof of RV, pull the quilt carefully from the tip to the front of RV until the quilt is on the right kind position.

(Tip: If you’re feeling hard to moving forward, check if the quilt is stuck by any corners or sharp edges of RV roof. If it was once stuck, operators can move to pockets at the middle of canopy, and pull again.)

4, Release the front panel from velcro, zip all zippers, put all buckles & straps on, and done.

3 layer polypropylene best fabric helps to keep out rain and snow at the same time as single layer polypropylene side fabric venting inside of vapor out
More than one zippered panels for simple get right of entry to to the front, back & sides
Air vents cut back wind stress and vent inside of moisture out
New methods of putting in RV cover save it slow
Fits 30′-33′ RV, Size: 402″L*102″W*104″H

Brand

Color

EAN

EANList

ItemDimensions

Label

Manufacturer

Model

MPN

PackageQuantity

PartNumber

ProductGroup

Publisher

Studio

UPC

UPCList

Reviews

There are no reviews yet.

Be the first to review “New Easy Setup Travel Trailer Cover Fits RV Camper with Assist Steel Pole (30′-33′)”

Your email address will not be published. Required fields are marked *